Set Eap User Name; Set Inner Authentication - Honeywell RP2F Series User Manual

Set EAP User Name

Sets the EAP (Extensible Authentication Protocol) user name to log on to the network.
Only users with administrative privileges can set this command.
Command
ESC{SWF:U:<sexp>}ESC EZ{COMMIT}{LP}
where:
<sexp> is a valid user name. <sexp> can be up to 96 characters, but Intermec
recommends a user name that is eight characters or shorter. The default EAP user
name is "anonymous".
Example
This command sets the EAP user name to "Gandalf."
ESC{SWF:U:Gandalf}ESC EZ{COMMIT}{LP}
Returns this reply if the command is not successful:
{SWF:U:1}
Returns this reply if the command is successful:
{SWF:U:0}

Set Inner Authentication

Sets the inner authentication type. This setting is only used when
to either TTLS or PEAP. The Inner Authentication value is only shown on the network
test label if the printer is using 802.1x security.
Only users with administrative privileges can set this command.
Command
ESC{SWF:IA:<sexp>}
where the values for <sexp> are:
0: PEAP. Use PEAP for TTLS, only
1: MSCHAPv2. PEAP also uses EAP in the tunnel, so PEAP for MSCHAPv2 and
EAP/MSCHAPv2 are equivalent settings.
2 (default): EAP/MSCHAPv2. PEAP also uses EAP in the tunnel, so PEAP for
MSCHAPv2 and EAP/MSCHAPv2 are equivalent settings.
3: EAP/MD5
4: EAP/GTC
52
Set EAP Type
EZ-Print Command Reference
is set