Snapshot - D-Link DCS-F Series User Manual

Camera User Manual
Parameter
Enable
Area ID
Level
Area Name
Step 3 Click Draw to show the red frame, drag the four corners of rectangle to adjust the position.
Step 4 Click Apply.
The message "Apply success!" is displayed, and the system saves the settings.
----End

Snapshot

Procedure
Step 1 Click Configuration > Stream > Snapshot.
The ROI page is displayed, as shown in Figure 4-4.
Step 2 Set the parameters according to Table 4-3.
Issue V1.0 (2023-02-10)
Description
Enable the ROI
ROI area ID
The visual effect of ROI. The higher the level is, the
clearer the area is; the more blurred outside the area.
The marked name used for areas.
Snapshot Configuration Page
Configure the Device
Setting
[Setting method]
Click the button.
[Default value]
OFF
[Setting method]
Select a value
from the drop-
down list box.
[Default value]
1
[Setting method]
Select a value
from the drop-
down list box.
[Default value]
5
[Setting method]
Enter a value
manually. The
value cannot
exceed 32 bytes.
47