Makita WT001G Instruction Manual page 8

1. Loosen the two screws while holding the outer
sleeve. The outer and inner sleeves will be pushed up
by the springs built into the tool.
Fig.6
► 1 . Outer sleeve 2. Screw
2. Press the pin down to remove the inner sleeve
from the outer sleeve.
Fig.7
► 1 . Inner sleeve 2. Pin 3. Outer sleeve
NOTICE:
Be careful not to drop the inner sleeve
when removing it.
NOTICE:
Do not remove the tip rod, tip rod
spring, and inner sleeve spring from the tool.
Fig.8
► 1 . Tip rod 2. Tip rod spring 3. Inner sleeve spring
Installing the outer and inner
sleeves
1
Place the inner sleeve with the pin facing upward.
Attach the outer sleeve to the inner sleeve securely
while pressing the pin of the inner sleeve.
2
Fig.9
► 1 . Outer sleeve 2. Pin 3. Inner sleeve
1
Insert the outer and inner sleeves into the tool while
rotating the inner sleeve clockwise and counterclock-
wise until the outer sleeve touches the tool. Tighten the
2
two screws firmly.
3
1
2
3
Fig.10
► 1 . Outer sleeve 2. Screw
NOTICE:
the outer sleeve and the tool.
8 ENGLISH
2
Make sure that there is no gap between
1
2
3
1