Adjusting The Mowing Height - Makita LM001C Instruction Manual

Indicating the remaining battery capacity
When the remaining battery capacity becomes low, the
indicator lamp blinks or lights up.
► Fig.25: 1. Indicator lamp
Indicator lamp
Off Blinking
NOTE: The indicator lamp for remaining battery
capacity is just for a reference. The actual bat-
tery capacity may differ depending on the usage
conditions.
NOTE: The display of the indicator lamp is updated
when the machine stops operation.
Switch action
WARNING:
Before installing the portable
power pack, always check to see that the switch
lever actuates properly and returns to the original
position when released. Operating the machine with
a switch that does not actuate properly can lead to
loss of control and serious personal injury.
NOTE: The mower does not start without pressing the
switch button even the switch lever is pulled.
NOTE: Mower may not start due to the overload
when you try to mow long or dense grass at a time.
Increase the mowing height in this case.
This mower is equipped with the lock key and handle switch.
If you notice anything unusual with either of the lock key
or switch, stop the operation immediately and have them
checked by your nearest Makita Authorized Service Center.
1. Install the portable power pack, and then insert the lock key.
2. Press the power button on the portable power
pack. The main power lamp will light up.
For PDC1200
► Fig.26: 1. Power button 2. Main power lamp
For PDC01
► Fig.27: 1. Power button 2. Main power lamp
3.
Press the main power switch.
4. Pull the switch lever toward you while holding
down the switch button. Release the switch button as
soon as the motor starts running.
► Fig.28: 1. Switch button 2. Switch lever
NOTE: If the lock key is not inserted, the power lamp
blinks in green when you pull the switch lever.
5. While holding the switch lever, push the drive lever
forward and hold it to drive the rear wheels.
► Fig.29: 1. Drive lever
Remaining
capacity
Lighted
20% to 100%
0% to 20%
Charge the
battery.
16 ENGLISH
NOTE: You can drive the rear wheels by pushing
the drive lever forward and hold it without pulling the
switch lever.
6.
Release the drive lever and the switch lever to
stop the machine.

Adjusting the mowing height

WARNING:
Never put your hand or leg under
the mower body when adjusting the mowing height.
WARNING:
Always make sure that the lever
fits in the groove properly before operation.
The mowing height can be adjusted in the range of
between 20 mm and 100 mm.
Remove the lock key, and then pull the mowing height
adjusting lever outward of the mower body and move it
to your desired mowing height.
► Fig.30: 1. Mowing height adjusting lever
The table below shows the relationship between the number
on the mower body and the approximate mowing height.
Number
1
2
3
4
5
6
7
8
9
10
Hold the front grip or the lower handle with one hand, and then
move the mowing height adjusting lever with the other hand.
► Fig.31: 1. Mowing height adjusting lever 2. Lower
handle 3. Front grip
NOTE: The mowing height figures should be used
just as a guideline. Depending on the conditions of
the lawn or the ground, the actual lawn height may
become slightly different from the set height.
NOTE: Try a test mowing of grass in a less conspicu-
ous place to get your desired height.
Grass level indicator
Grass level indicator shows the volume of mowed
grass. When the grass basket is not full, the indicator
floats while the blades are running.
► Fig.32: 1. Grass level indicator
When the grass basket is almost full, the indicator does
not float while the blades are running. In this case, stop
the operation immediately and empty the basket.
► Fig.33: 1. Grass level indicator
NOTE: This indicator is a rough guide. Depending on
the conditions of inside of the basket, this indicator
may not work properly.
Mowing height
20 mm
26 mm
32 mm
39 mm
47 mm
55 mm
63 mm
74 mm
86 mm
100 mm