Makita RP1800 Instruction Manual page 11

Dust nozzle set (Accessory)
1
► 1 . Dust nozzle 2. Clamping screw
Use the dust nozzle for dust extraction. Install the dust
nozzle on the tool base using the thumb screw so that
protrusion on the dust nozzle fit to the notch in the tool
base.
Then connect a vacuum cleaner to the dust nozzle.
2
How to use screw M6 x 135 for
adjusting the depth of cut
When using the tool with a router table available in the market,
using this screw allows an operator to obtain a small amount
of adjustment of the depth of cut from above the table.
Installing the screw with washer on
the tool
Insert the screw with washer through a screw hole on
the tool base and then screw in the threaded part of the
motor bracket of the tool. At this time, apply some grease
or lubricating oil to the inside of the screw hole on the tool
base and the threaded part of the motor bracket.
► 1 . Flat washer 6 2. Screw M6x135
► 1 . Screw M6 x 135 in a screw hole
1
► 1 . Screw M6x135 2. Threaded part in the motor
bracket
11 ENGLISH
1
2
1
2