Makita RP1800 Instruction Manual page 10

To install the templet guide, pull the lock plate lever and
insert the templet guide.
1
2
► 1 . Template guide 2. Lock plate
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1
2
3
4
5
► 1 . Bit 2. Base 3. Templet 4. Workpiece 5. Distance
(X) 6. Outside diameter of the templet guide
7. Templet guide
NOTE:
• The workpiece will be cut a slightly different
size from the templet. Allow for the distance (X)
between the bit and the outside of the templet
guide. The distance (X) can be calculated by
using the following equation:
Distance (X) = (outside diameter of the templet guide
- bit diameter) / 2
7
6
Trimmer guide (optional accessory)
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
Install the trimmer guide on the guide holder with the
clamping screw (B). Insert the guide holder into the
holes in the tool base and tighten the clamping screw
(A). To adjust the distance between the bit and the trim-
mer guide, loosen the clamping screw (B) and turn the
fine adjusting screw (1.5 mm per turn). When adjusting
the guide roller up or down, loosen the clamping screw
(C). After adjusting, tighten all the clamping screws
securely.
1
2
3
► 1 . Guide holder 2. Adjusting screw 3. Clamping
screw (B) 4. Clamping screw (C) 5. Trimmer guide
6. Clamping screw (A)
When cutting, move the tool with the guide roller riding
the side of the workpiece.
3
► 1 . Bit 2. Guide roller 3. Workpiece
10 ENGLISH
4
6
5
1
2