Attaching The Antenna; Removing And Attaching The Accessory Connector Cover; Attaching The Belt Clip - Motorola APX 4000XH User Manual

MN001824A01-AT
Chapter 2: Getting Started
2.3

Attaching the Antenna

Prerequisites: Ensure the radio is turned off before attaching the antenna.
Procedure:
1. Set the antenna in the receptacle.
2. Turn the antenna clockwise to attach to the radio.
3. To remove the antenna, turn the antenna counterclockwise.
NOTE: When removing the antenna, ensure that the radio is turned off.
2.4
Removing and Attaching the Accessory Connector
Cover
The accessory connector is on the antenna side of the radio. It is used to connect accessories to the radio.
NOTE: To prevent damage to the connector, shield it with the connector cover when not in use.
Procedure:
1. To remove the accessory connector cover, rotate the thumbscrew counterclockwise until it disengages
from the radio.
NOTE: If the thumbscrew is too tight, use a screwdriver to loosen it.
2. Rotate and lift the connector cover to disengage it from the radio.
3. To attach the accessory connector cover, insert the hooked end of the cover into the slot above the
connector.
4. Press the top of the cover downward to seat it in the slot.
5. Tighten by rotating the thumbscrew clockwise by hand.
2.5

Attaching the Belt Clip

Procedure:
1. Align the grooves of the belt clip with those of the radio and push down until you hear a click.
2. To remove the clip, use a flat-bladed object to press the belt clip tab away from the radio.
3. Slide the clip upward and away from the radio.
18