Table of Contents
Advertisement
Radio auto playback the most recent incoming call followed by saved calls in chronological order.
Radio displays the playback status.
NOTE:
Received call overwrites the ongoing record playback. User can short press the programmable
button within three seconds to continue the playback and ignore the receiving call.
User can short press the programmable button to trigger playback when the radio is receiving
call to overwrite the receiving call.
Playback can be halted by any tone and button press except for specific buttons. Check with
your dealer or system administrator for more information.
7.8
In-Call User Alert
This feature allows the radio to remain muted to affiliated talkgroup calls or dispatch calls while operating on
the current Trunking Personality or conventional channel respectively.
Group and individual Pages unmute the radio for the alert tone to sound. The radio also unmutes to individual
radio-to-radio calls. This feature is very useful when a radio-user prefers not to hear affiliated talkgroup or
dispatch calls traffic, but needs-to remain in radio contact. For an In-Call User Alert enabled channel, the
Voice Mute button-press or the Voice Mute menu-selection allows the radio-user to toggle on and off Voice
Mute functionality.
7.9
Quik Call II
This feature allows you to broadcast a series of distinct and recognizable tones before a voice transmission
from the dispatcher or a radio.
The broadcasting dispatcher or radio user can select this programmed Quik Call II tone transmission to be
sent to an individual talkgroup or over the entire system. Each tone is distinctive to indicate different situation
or different broadcaster.
NOTE: The receiving radio must be configured with the matching Quik Call II tone from the transmitting
radio, in order for the receiving radio to sound the selected tone followed by the preconfigured alert
tone.
7.9.1
Initiating Quick Call II Transmissions
Prerequisites: Tone must be preprogrammed into the Tone Signaling List on the broadcasting or transmitting
radio.
Procedure:
1.
or
to QCII, and press the Menu Select button directly below QCII.
2.
or
to select the tone to broadcast.
3. Press the PTT to broadcast the selected tone, or press and hold the PTT to broadcast the selected
tone and transmit with your vocal transmission.
You hear the radio sounds the selected tone. You can begin your call after the tone ends.
MN001824A01-AT
Chapter 7: Advanced Features
67
Advertisement
Table of Contents
