Finisher-Ab1/Saddle Finisher-Ab2/Punch Unit-U1/W1/X1 (Optional); Replacing The Staple Cartridge In The Stapler Unit - Canon imagePRESS C7000VP Reference Manual

Finisher-AB1/Saddle Finisher-AB2/Punch Unit-U1/W1/X1
(Optional)
This section describes the procedure for replacing the staple cartridge in the
optional Finisher-AB1 or Saddle Finisher-AB2, and removing the punch waste
from the optional Punch Unit-U1/W1/X1.
Replacing the Staple Cartridge in the Stapler
Unit
When the optional Finisher-AB1 or Saddle Finisher-AB2 is almost out of
staples, and the staple cartridge in the stapler unit must be replaced, a
screen similar to the one shown below appears on the touch panel display.
Follow the procedure described below to replace the staple cartridge.
Use only staple cartridges intended for use in this machine.
IMPORTANT
Take care when handling the optional equipment that is attached to the
machine. When an optional unit's cover is opened to replace a staple
cartridge, discard punch waste, or clear paper or staple jams, prints may
still be output if other optional units are operating normally, and are not
involved in the paper or staple jam removal procedure.
NOTE
We recommend that you order staple cartridges from your local authorized
Canon dealer before your stock runs out.
1
Open the front cover of the finisher.

Finisher-AB1/Saddle Finisher-AB2/Punch Unit-U1/W1/X1 (Optional)

A7-39