Table of Contents
Advertisement
4-5.
Cooling Fan
4-5-1.
Front Fan Assembly
Preparation
1.
Refer to
"4-2. Flow
Chart".
Procedure
1.
Remove the wire holder.
2.
Open the two wire clamps and release the harness.
3.
Disconnect the harness from the connector (CN1) on the CN-3837 board.
4.
Remove the two screws to detach the front fan assembly.
Wire holder
CN1
(CN-3837 board)
Harness
Note
• When installing the front fan assembly, do not put the harness between any parts.
• Avoid impact on the front fan assembly.
5.
Install the removed parts by reversing the steps of removal.
PWS-4500
Harness
Wire clamps
PSW3 x 6
Front fan assembly
4-8
Advertisement
Table of Contents
