Table of Contents
Advertisement
4-3-3.
Front Panel Assembly
Preparation
1.
Refer to
"4-2. Flow
Chart".
Procedure
1.
Remove the four screws from the sides of the unit.
2.
Release the harness from the two clamps.
3.
Disconnect the harness from the connector (CN002) on the SW-1628 board, and then remove the front panel
assembly.
PSW3 x 6
Front panel assembly
PSW3 x 6
PSW3 x 6
Front panel assembly
Note
When installing the front panel assembly, move the front panel assembly in the direction of the arrow and tighten
the screws.
4.
Install the removed parts by reversing the steps of removal.
PWS-4500
SW-1628 board
Clampers
CN002
Harness
Front panel assembly
PSW3 x 6
4-6
Advertisement
Table of Contents
