Kenwood TS-930S Instruction Manual page 18

Hide thumbs Also See for TS-930S:

Table of Contents

@® RITY KEY jack (1

Jack for FSK operation. Connect this directly to the low

voltage (5 V DC or tess) terminal unit output using an RCA

plug. DO NOT connect @ 60 MA locatloop direct: use a

keying relay to provide a switched ground.

@ Power connector

Connector for AC power source. Make certain the

transceiver's voltage selector is adjusted to your local fine

voltage BEFORE turn-on.

@ Ac FUSE

This fuse protects the power supply against short circuits.

Never use a higher amperage fuse than specified; it will

eventually cause extensive damage. !f the fuse blows, try

to determine the cause

before replacing.

For 120 volt

operation, use a 6 ampere fuse. For 220/240 volt, use a 4

ampere fuse.

@® EXT. SP (speaker) jack (R)

@® cw. KEY jack (T}

@ Cooling fan (final section}

@ Cooling fan {power supply)

Electronic-controlied automatic cooling fan for the power

supply section.

Table of Contents