Antenna Connector; Remote Connector - Kenwood TS-930S Instruction Manual

(@) ANTENNA CONNECTOR
This SO-239
coax connector
should
be attached
to a
suitable 50 9 antenna for transmitting and receiving.
@® GND (ground) terminal
To prevent electric shock, as well as RFI and BCI, connect
the transceiver to a good earth ground.
@® RX. ANT output switch
@® RX. ANT terminal
© XVERTER (transverter) terminal
This 8 Pin DIN connector is used to interface a VHF or UHF
transverter.
Relay contrat (+0n
2 |
transerit)
&:
'Transvertet ALC input
3 | Ground
7 | Transverter output {7X}
4 | X.verter ON-OFF controt
6 | HF ANT output
a fy < i
AY
mY
AX ARG
uy
DOR Koha
} ' Ay
Fim WO ANE
Aelay Cott -
(112 oN ean, A 0 al
AF IN PUT
5 From transvertor
ON-OFF Sw
Feam Transverter ALC
@ REMOTE CONNECTOR
This connector is used to interconnect a linear amplifier or
@® WF OUT jack (R)
A high-level, narrow-bandwidth 100 kHz IF output, taken
before the receiver produce detector, for scope display
of
PHONE PATCH jacks
17