Table of Contents
Advertisement
Section 1
Introduction
Although warning hazards are related to personal injury, it is necessary to understand that under
certain operational conditions, operation of damaged equipment may result in degraded process
performance leading to personal injury or death. It is important that the user fully complies with all
warning and cautionary notices.
1.4.2
Document conventions
•
Abbreviations and acronyms in this manual are spelled out in the glossary. The glossary also
contains definitions of important terms.
•
Parameter names are shown in italics.
For example, the function can be enabled and disabled with the Operation setting.
•
Each function block symbol shows the available input/output signal.
•
•
•
Dimensions are provided both in inches and millimeters. If it is not specifically mentioned then
the dimension is in millimeters.
1.5
IEC 61850 Edition 1, Edition 2, and Edition 2.1 mapping
Function block names are used in ACT and PST to identify functions. Respective function block
names of Edition 1, Edition 2, and Edition 2.1 logical nodes are shown in the table below.
Table 1:
Function block name
-
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BTIGAPC
DPGAPC
DRPRDRE
INDCALH
ITBGAPC
L4UFCNT
LD0LLN0
LPHD
MVGAPC
Table continues on next page
8
The information icon alerts the reader of important facts and conditions.
The tip icon indicates advice on, for example, how to design your project or how to use a
certain function.
the character ^ in front of an input/output signal name indicates that the signal name may
be customized using the PCM600 software.
the character * after an input signal name indicates that the signal must be connected to
another function block in the application configuration to achieve a valid application
configuration.
IEC 61850 Edition 1, Edition 2, and Edition 2.1 mapping
Edition 1 logical nodes
-
AGSAL
SECLLN0
ALMCALH
-
-
-
B16IFCVI
DPGGIO
DRPRDRE
INDCALH
IB16FCVB
L4UFCNT
LLN0
LPHD
MVGGIO
© 2017 - 2023 Hitachi Energy. All rights reserved
1MRK511447-UEN Rev. E
GUID-96DFAB1A-98FE-4B26-8E90-F7CEB14B1AB6 v9
GUID-C5133366-7260-4C47-A975-7DBAB3A33A96 v10
Edition 2 and Edition 2.1 logical
nodes
ALGOS
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BTIGAPC
DPGAPC
DRPRDRE
INDCALH
ITBGAPC
L4UFCNT
-
MVGAPC
Switchgear control unit SAM600-IO
Commissioning manual
Advertisement
Table of Contents
