Configuring General Settings Using Gui - Cisco IEC6400 Installation And Configuration Manual

Table of Contents

Configuring General Settings using GUI

Before you begin

By default, when the General Mode window is opened for the first time, the Local IP, Local netmask, and

LAN parameters fields are with factory-set default values.

The general mode window contains controls on how to monitor and/or change the following settings:

• Shared network passphrase

• Gateway's LAN parameters

To change the General Mode settings, follow these steps:

Step 1

In the GENERAL SETTINGS, click general mode.

The GENERAL MODE window appears.

Step 2

In the General Mode section, verify that the Mesh Passphrase field is set as desired.

Step 3

In the LAN Parameters section, enter the following details:

• Enter the local IP address in the Local IP field.

• Enter the local netmask address in the Local Netmask field.

• Enter the default gateway IP address in the Default Gateway field.

• Enter the local primary DNS IP address value in the Local Dns 1 field.

• Enter the local secondary DNS IP address value in the Local Dns 2 field.

Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0

Configuring the Gateway Initially in Provisioning Mode

Table of Contents