Gateway Fails To Connect To The Network - Cisco IEC6400 Installation And Configuration Manual

Gateway Fails to Connect to the Network

Gateway Fails to Connect to the Network
Before you begin
Verify the following for the gateway:
• It is in the correct VLAN.
• It can reach the DHCP server.
• The DHCP server has an IP address assigned to the gateway.
To connect to the network, follow these steps:
Step 1 If needed, enter the values for the following fields in IOT OD IW window:
• Local IP
• Local Netmask
• Default Gateway
• Local Dns 1
• Local Dns 2
Step 2 Click Save fallback IP.
The web browser shows the gateway reboot window appears.
Step 3 Click OK, then the gateway reboots and remains in provisioning mode and the gateway tries to connect to the network
using the new connection values.
Step 4 If the gateway cannot connect to the network using the DHCP settings, IOT OD IW Cloud connection info status is
shown as Disconnected.
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
26
Configuring the Gateway Initially in Provisioning Mode