Maintenance; Replacing Carbon Brushes - Makita 3601B Instruction Manual

1
2
3
4
► 1. Wing bolt (B) 2. Fine adjusting screw 3. Wing bolt
(A) 4. Trimmer guide 5. Wing bolt (C) 6. Guide roller
When cutting, move the tool with the guide roller riding
the side of the workpiece.
3
► 1. Bit 2. Guide roller 3. Workpiece

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.

Replacing carbon brushes

► 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the rear cover.
6
5
► 1. Screwdriver 2. Rear cover
1
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Then install the rear cover with the screws.
2
► 1. Brush holder cap 2. Screwdriver
•
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
1
7 ENGLISH
CAUTION:
Do not turn the tool on without the rear cover
installed in place.
1
2
1
2