Changing A Wash Program - Baumatic OMBRA4BL Instruction Manual

o Close the door firmly, so that you hear the door lock click shut.
o Press the ON/OFF key (A) to switch the machine on, the LED
display will light up and show "P0".
o Check whether the salt required icon (J) or rinse aid required
icon (K) are lit. If they are and you usually utilise separate salt
and rinse aid, then before continuing with the wash program you
should fill the dishwasher with salt and/or rinse aid.
o Press the program selection key (B) until the program that you
require appears on the LED display.
o Select any program option that you want to use (e.g. delay start,
additional rinse etc).
o IMPORTANT: If you are using "3 in 1" detergent tablets and not
also using separate dishwasher salt and rinse aid, after selecting
your wash program you must press the "3 in 1" key (E). The "3
in 1" icon (E1) will light on the LED display.
o Start the wash cycle by pressing the start program key (F), after
a few seconds, you will hear the appliance begin to fill with water
and the wash program will have started.
o The door locked icon (P) will light and the LED display will show
the time remaining until the end of the wash cycle.
Changing the wash program
o Whilst the program number still flashes on the LED display, the
wash program has not been confirmed and it is possible to alter
the wash program using the program selection key (B).
o Once the wash cycle is in progress, we do not recommend that
you attempt to change the wash program.
o However if you do wish to do this, you should press and hold
down the program selection key for 3 seconds to cancel the
wash cycle in progress. The LED display will show "00" and you
will hear the appliance pump out the water in the appliance.
o An audible signal will sound when the appliance has finished
pumping out.
o Press the ON/OFF key (A) to switch the appliance off. You can
then set a new wash program, by following the "setting a wash
program" section of this manual.
22