Changing A Wash Program; At The End Of A Wash Program - Baumatic BDI680 User Manual

o If you open the door during the wash program, the wash cycle
will stop. When you close the door again, after 10 seconds, the
wash cycle will restart.
Changing the wash program
o Open the door slightly and then wait a few seconds.
o Press and hold down the program selection button (8) for 3
seconds to cancel the wash program. Then use the program
selection button (8) to choose the correct wash program.
o Select any program options that you want to use (e.g. delay
start or half load option).
o Close the door firmly, so that you hear the door lock click shut.
o After a few seconds, you will hear the appliance begin to fill with
water and the wash program will have started.

At the end of a wash program

o The time display will flash for 8 seconds and a buzzer will sound.
o If you have used the delay start mode, the time display will flash
for 8 seconds but the buzzer will not sound.
o Open the door of the appliance.
o Use the ON/OFF button (1) to switch the dishwasher off and
unload the dishwasher.
o IMPORTANT: It is recommended that you wait about 15
minutes after a program has finished before unloading the
dishwasher.
sufficiently cooled and dried before you handle them.
o You should unload the lower basket first to avoid water dripping
down from the top basket and leaving streaks on the dishes in
the lower basket.
This will ensure that the dishes have
24