Lenovo ThinkSystem SD650 Manual page 134

CIM Prefix: PLAT CIM ID: 0536
User Action:
Information only; no action is required
• FQXSPUN0026I: Device [LogicalDeviceElementName] has been added.
This message is for the use case when an implementation has detected a Device was inserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0536
User Action:
Information only; no action is required
• FQXSPUN0047N: Sensor [SensorElementName] has transitioned to non-recoverable.
This message is for the use case when an implementation has detected a Sensor transitioned to non-
recoverable.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0530
User Action:
Complete the following steps:
1. Check the Lenovo support site for an applicable service bulletin or firmware update that applies to
this error.
2. Reboot the system.
3. If problem persists, collect Service Data log and Contact Lenovo Support.
4. For 1-2 Processor system:
a. Reduce the compute board/system in error to a minimum configuration; 1 CPU + 1 DIMM. Does
the problem still occur? Yes/No
b. No: Add CPU and/DIMMs one and a time until the error re-occurs. Consider replacing the last
CPU or DIMM that was installed that caused the error.
c. Yes: If there error/problem still exists, swap in one of the other DIMMs and/or CPUs previously
removed in step a. Proceed to add HW one piece at a time to identify the bad CPU or DIMM.
d. If the problem still exist, (trained technician only) replace system board.
e. If problem persists, escalate to next level of support.
5. For 4-8 Processor system:
a. Escalate to a next level of support.
• FQXSPUN0056G: Sensor [SensorElementName] has asserted.
This message is for the use case when an implementation has detected a Sensor has asserted.
Severity: Warning
130
ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Messages and Codes Reference