Lenovo ThinkSystem SD650 Dual Node DWC Tray Quick Start

ThinkSystem SD650 Dual Node DWC Tray
and NeXtScale n1200 DWC Enclosure
Type 7X58 and 5468
Quick Start
Your shipping box contains the following items:
n1200 DWC Enclosure
⚫
SD650 Dual Node DWC tray (up to six, installed in the enclosure)
⚫
Material box, including printed documentation
⚫
If any item is missing or damaged, contact your place of purchase.
Ensure that you retain your proof of purchase and packing material.
They might be required to receive warranty service.
First glance
Tray front view:
Left node (odd bay numbers)
Right node (even bay
numbers)
Dedicated RJ45 port for
Lenovo XClarity Controller
access
USB 3.0 connector
System error LED (yellow)
Note:
Depending on the configuration, the illustration above might differ
slightly from your server.
Server front view
Identification LED (blue)
Power button/LED (green)
1Gb Ethernet RJ45 port
KVM breakout cable
connector
Tray label
Enclosure rear view:
Server rear view
Power supply
Fan and Power Control
Module
Setting up the System
Install the required solution components.
1.
Install the enclosure into the rack.
2.
See the Rack Installation Guide that was provided with the rail kit.
Connect the cables.
3.
Connect the management controller to the network.
4.
Power on the nodes.
5.
Configure the system.
6.
For detailed information about installing hardware options and
configuring the system, see the following website:
http://thinksystem.lenovofiles.com/help/topic/SD650/introduction.html
PN: SP47A36245
Printed in China
Drip sensor assembly
Manifold