Sharp MX-B402 Operation Manual page 81

When using the MX-B402SC
1
When closing the automatic document feeder, take care that your fingers do not become pinched.
2
3
• Do not insert your hand into the document insertion opening in the automatic document feeder.
• If originals are placed higher than the line, misfeeds may occur.
• Before inserting originals into the document feeder tray, be sure to remove any staples or paper clips.
• If originals have damp spots due to correction fluid, ink or pasteup glue, wait until the originals are dry before making
copies. Otherwise the interior of the document feeder or the document glass may be soiled.
• When using originals with two or three holes, place them so that
the punched edge is at a position away from the feed slot of the
document feeder tray.
Make sure an original does not remain
on the document glass.
Open the automatic document feeder, make sure that an
original is not on the document glass, and then gently close the
automatic document feeder.
Adjust the original guides to the size of
the originals.
Place the originals.
Make sure the edges of the originals are even.
Indicator
Insert the originals face up all the way into the document feeder
line
tray.
Insert a number of originals that does not exceed the indicator
line on the document feeder tray.
Up to 100 sheets can be inserted.
Please remove originals that have finished being read with the
automatic document feeder from the original output portion's
upper exit or heavy exit. Heavy paper (34 lbs. to 75 lbs.
2
(129 g/m to 280 g/m
heavy exit.
Feed slot
1-40
BEFORE USING THE MACHINE
2
)) and plastic cards can be output only on
Contents
Hole
positions