Remove The Connection And/Or Other Cable(S) - Honeywell VERSAFLOW SONIC 1000/TWS 9000 Handbook

VERSAFLOW SONIC 1000/TWS 9000

7.9.1 Remove the connection and/or other cable(s)

DANGER!
The device MUST be disconnected from mains power before disassembling.
Connection cable materials consist of (several) metal conductor (usually copper), surrounded
with a flexible plastic insulation.
Signal cables can be made from coaxial cables consisting of a one or two copper conductor(s)
with a metal tabular shielding and surrounded with one or more insulation layer(s).
For more details refer to
Stainless steel sensor versions
• The signal cable can be removed by unplugging of the cable (s) inside of the sensor rail and
unscrewing the cable gland from the sensor rail. The cable can then be pulled out of the
sensor housing.
Depending on the version of the signal converter (F, W or R version) the cable can be
disconnected in the terminal compartment of the housing. For more details, refer to
supply
on page 57.
Disconnect cable from signal converter
• Wall version Wall version: open compartment door of the W housing
Wall version Wall version
• Disconnect all cables from terminals
• Dismount the cable glands and pull the wiring out of the housing
• Field version Field version: unscrew the cover of the sensor terminal compartiment
Field version Field version
• Loosen the grounding clamps
• Disconnect all cables from terminals
• Dismount the cable glands and pull the wiring out of the housing
34-VF-25-07 iss.2 GLO Nov 11 US
Electrical connections signal converter
www.process.honeywell.com
SERVICE
on page 56.
Power
7
163