Draytek Vigor2927 Series Quick Start Manual page 3

H a r d w a r e I n s
H a r d w a r e I n s
1. Connect the cable Modem/DSL
Modem/Media Converter to any
WAN port of router with Ethernet
cable (RJ-45).
2. Connect one end of an Ethernet
cable (RJ-45) to one of the LAN
ports of the router and the other
end of the cable (RJ-45) into the
Ethernet port on your computer.
3. Connect one end of the power
adapter to the router's power
port on the rear panel, and the
other side into a wall outlet.
4. Power on the device by pressing down the power switch on the rear panel.
5. The system starts to initiate. After completing the system test, the ACT LED will
light up and start blinking.
W a l l - M o u n t e
W a l l - M o u n t e
Vigor router has keyhole type mounting slots
on the underside.
1. Drill two holes on the wall. The
distance between the holes shall be
168mm.
2. Fit screws into the wall using the
appropriate type of wall plug.
The recommended drill
diameter shall be 6.5mm
Note
(1/4").
3. When you finished about procedure,
the router has been mounted on the
wall firmly.
t a l l a t i o n
t a l l a t i o n
d I n s t a l l a t i o n
d I n s t a l l a t i o n