Attaching The Shoulder Strap; Operation - Makita VR1000 Instruction Manual

5. Make sure that the shaft is locked by pulling the
shaft.
► 1. Shaft
To remove the flexible shaft, pull the lever, and then pull
out the shaft.
► 1. Shaft 2. Lever

Attaching the shoulder strap

WARNING:
Do not use the parts for attaching
the shoulder strap for other purposes, such as
the fall prevention at high location. If the parts
for attaching the shoulder strap are used for other
purposes, excessive load may break them and cause
serious injury to the operator and person around/
underneath the operator.
CAUTION:
Be sure to attach the hooks of the
shoulder strap to the tool securely. If the hooks
are attached incompletely, they may come off and
cause injury.
CAUTION:
Be sure to use the shoulder strap
dedicated to this tool. Using other shoulder strap
may cause an injury.
1
1 2
Attach the hooks of the shoulder strap to the tool as
shown in the figure.
► 1. Hook 2. Shoulder strap

OPERATION

CAUTION:
Put the shoulder strap on the
shoulder, and hold the tool firmly with both
hands.
Hold the tool straight when inserting or operating. Use
the tool within the effective vibration range at equidis-
tant intervals. The effective air bubble removal range
is about ten times diameter of the vibrating head, or
approximately 350 mm (13-3/4").
6 ENGLISH
1 2
1