Makita VR1000 Instruction Manual page 5

Switch action
CAUTION:
Before plugging in the tool, always be
sure that the tool is switched off.
► 1. Switch
To start the tool, press the position marked (I) on the
switch. To turn off the tool, press the position marked (0)
on the switch.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Installing or removing the flexible
shaft
Optional accessory
To install the flexible shaft, follow the steps below.
1.
Pull the lever to release the lock pin.
1
► 1. Lever
2.
aligning the hole on the shaft with the triangle mark on
the tool.
1
► 1. Shaft
3.
and then return the lever.
► 1. Hole 2. Pin 3. Lever
4.
pulling the shaft.
► 1. Shaft 2. Lever
5 ENGLISH
Insert the flexible shaft into the tool until it stops
1
Align the hole on the shaft with the pin on the tool,
1 2
Lock the shaft with the pin by slightly turning and
3
1 2