Set Up A Static Route - NETGEAR MR90 User Manual

Here is an example static route setting for this configuration:
• Destination IP address and subnet mask settings: The route applies to all addresses
at the remote site, so set the destination IP address to 134.177.0.0 and the subnet
mask to 255.255.255.0.
• Gateway IP address: Traffic for addresses in the 134.177.0.0 network must be
forwarded to the ADSL router, so set the gateway IP address to 192.168.1.100 (the
ADSL router's address on your LAN).
• Private route: Make the static route private as a security precaution in case Routing
Information Protocol (RIP) is activated. A private route is not reported in RIP messages.

Set up a static route

To set up a static route:
1. Launch a web browser from a computer or mobile device that is connected to your
mesh network.
2. Enter http://www.routerlogin.net.
A login window opens.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > Static Routes.
The Static Routes page displays.
5. Click the Add button.
The page adjusts.
6. In the Route Name field, type a name for this static route (for identification purposes
only).
7. To limit access to the LAN only, select the Private check box.
If the Private check box is selected, the static route is not reported in RIP.
8. To prevent the route from becoming active, clear the Active check box.
Manage Network Settings
Nighthawk Tri-band Mesh WiFi 6E
95 User Manual