Makita LS0816F Instruction Manual page 22

Table (B)
– Molding
position in
the figure
For inside (a)
corner
(b)
For outside (c)
corner
(d)
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
• Tilt and secure bevel angle setting to 33.9° LEFT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on the
saw.
• The finished piece to be used will always be on
the LEFT side of the circular saw blade after the
cut has been made.
Molding Finished
edge against piece
guide fence
Ceiling Finished
contact edge piece will be
should be on the Left
against guide side of the
fence. circular saw
blade.
Wall contact
edge should
Finished
be against
piece will be
guide fence.
on the Right
Ceiling side of the
contact edge circular saw
should be blade.
against guide
fence.
22 ENGLISH