Problems With Configuration Diskette Creator; Problems With Windows Server 2003 - NEC Bull NovaScale R620 User Manual

Problems with Configuration Diskette Creator


The bit map of the Configuration Diskette Creator window is not displayed correctly during settings of
setup information. (When the Trekking command is used)
 If the specified number of colours is fewer than 256 in the display setting, the bit map is not displayed
correctly, but the setup information can be displayed

The Point to Point tunnelling protocol cannot be set.
 The protocol is not supported at present. After installation, set the protocol through Control Panel. In
this case, rebooting is not necessary.

The details of a network adapter cannot be set.
 Configuration Diskette Creator is unable to set the details of network adapters. Start Windows 2003,
and set the details through Control Panel.

Problems with Windows Server 2003


The Telnet Service is not installed.
 Adjust the computer name to 14 characters or less, and then install the Telnet Service as follows:
1. Click [Run] on Start menu.
2. Type "tlntsvr /service" in the [Open] box, and click [OK].
3. Click Start menu, point to [Control Panel] and click [Computer Management] and then click the
* When the installation of Telnet Service is finished, there is no problem if the computer name is set
to 15 characters or more.
NovaScale R620 User Guide
[Services] to specify whether the Telnet Service is registered.
7-32