Expressbuilder; Start Menu - NEC Bull NovaScale R620 User Manual

EXPRESSBUILDER

The EXPRESSBUILDER, integrated setup software, can automatically detect the hardware connected to an
NovaScale/ft Server series machine to advance the processing. The hardware subject to setup with the
EXPRESSBUILDER should have the same configuration as that for operation.

Start Menu

The EXPRESSBUILDER provides three procedures to start the server as described below. The menus and items
appearing on the screen vary depending on the procedures.
Booting (starting) the server from EXPRESSBUILDER CD-ROM
For the procedure, insert the EXPRESSBUILDER CD-ROM into the
CD-ROM drive of the NovaScale/ft Server series and start the
NovaScale/ft Server series from the system in the
EXPRESSBUILDER. When the NovaScale/ft Server series is started
by using this procedure, the EXPRESSBUILDER top menu shown on
the right appears.
Setup the NovaScale/ft Server series from this menu.
IMPORTANT:
Do not use this CD-ROM on computers other than this server with which it is packaged (including other
NovaScale models). Otherwise, a breakdown may result.
The execution of "Setup" of the menu causes the OS installed previously to be erased. OS must also be
reinstalled.
See "EXPRESSBUILDER Top Menu" for details.
Inserting EXPRESSBUILDER CD-ROM after Windows start-up
The "Master Control Menu" (see figure on the right) starts
automatically after you place the "EXPRESSBUILDER" in the
CD-ROM drive. A dialog box called "Master Control Menu" will
appear.
For this dialog, see "Master Control Menu" described later.
NovaScale R620 User Guide
5-2