Multiplexer Connection And Associated Settings; Repeat Recording - Sony HSR-X200 Operating Instructions Manual

Settings
To activate series recording, set each of the connected
HSR-X200/X200P units as follows with 4.
RECORDING CONDITIONS SET of MAIN MENU
1.
For details on menu operations, see "Menu Operations" on
page 17(GB).
<RECORDING CONDITIONS SET>
SERIES RECORDING
NORMAL RECORDING AREA
OVERWRITE
ALARM RECORDING AREA
OVERWRITE
REMAINING DISK WARNING
Set SERIES RECORDING to ON.
Set OVERWRITE to OFF for both NORMAL
RECORDING AREA and ALARM RECORDING
AREA.
For details on OVERWRITE, see "Recording Area Settings"
on page 52(GB).
Notes
• Series recording cannot be performed if timer
recording has been specified.
Be sure that the TIMER button indicator is dark on
all the connected HSR-X200/X200P units.
• If the OVERWRITE function is set to ON on any of
the connected HSR-X200/X200P units, recording
will be continued on that unit.
To start series recording
Press the z REC button on the first HSR-X200/
X200P.

Repeat recording

You can continue recording (overwriting) by returning
to the first unit when the recording area of the last unit
becomes full.
To achieve this repeat recording, connect the SERIES
OUT and COM terminals of the last unit to the
SERIES IN and COM terminals of the first unit.
Note
This function is valid with normal recording and alarm
recording only.
: OFF
: OFF
: OFF
: 1%
Multiplexer Connection and
Associated Settings
Connection example
Multiplexer
VCR OUT VCR IN
VIDEO VIDEO
IN OUT
AUDIO
MIC IN OUT
PC CARD
IN LOOP OUT OUT IN LOOP OUT OUT
S-VIDEO VIDEO
HSR-X200/X200P
Settings
Specify the type of the connected multiplexer with
2. VIDEO INPUT/PRE REVERSE of MAIN MENU 1.
For details on menu operations, see "Menu Operations" on
page 17(GB).
<VIDEO INPUT>
MULTIPLEXER
<PRE REVERSE PLAY>
PRE REVERSE PLAY TIME : 10 MIN
SONY: Sony-made multiplexer (YS-DX516/DX516P,
etc.)
OTHERS1: Sanyo-made multiplexer
OTHERS2: Multiplexer of Dedicated Micro and
Robot
OTHERS3: Multiplexer of other manufacturers
NO USE: Not to use any multiplexer
SW (VEXT) IN
AL
+ C
ALARM ALARM
COM COM SW OUT
+ IN + OUT + COM
NON REC OUT WARNING OUT
ALARM CLOCK
RESET ALARM
COM IN OUT COM IN OUT FULL FULL
COM COM COM IN OUT COM COM
RS-232C
A B REMOTE SW OUT
SERIES
RS485
RS485
TERMINATE
ON
OFF
-AC IN
to an AC outlet
: NO USE
41
(GB)