Cisco 2504 Getting Started Manual page 5

Callout Port and LEDs
2 GigE port and LED
3 & 4 POE GigE Power-over-Ethernet
(POE) ports
RESET Reset button
PWR Power LED
SYS System LED
State and Description
The Gigabit Ethernet port is an RJ-45 connector
form-factor. This port is designed so that 1500 VAC rms
isolation (per the 802.3 specification) is met between
chassis ground and any 48V/Ethernet signal.
LED description:
Green or Blinking Green—Link activity
•
Off—No link
•
The Gigabit POE ports are RJ-45 connector form-factor.
They provide a I2C communications channel between
the PSE controller and host CPU TWSI bus #1. This
interface supports the proper voltage isolation as defined
by 802.3. The POE controller is configured to I2C
address 0x40/41 (0100 000r/w).
The POE controller reset is driven from system reset. If
software needs to reset the POE controller, it can do so
over I2C.
LED description:
Green or Blinking Green—Link activity
•
Off—No link
•
The ports can be used for infra-switch connection
Note
using multiple an AP-Manager or data interface.
Pushing the Reset button reboots the system.
The power LED light is on when all the power conversion
circuits are running normally.
LED description:
Green—Power is on
•
Off—No power to the system
•
The system LED determines if the system is powered up.
LED description:
Blinking Amber—Boot-loader is active and waiting
•
for user input from the system console.
Blinking Green—Boot-loader or booting.
•
Green—Normal System Operation.
•
Amber—System failed the bootup process or an
•
error caused the system to halt. A status or error
message is posted on the console screen.
• Off—System not receiving power.
Cisco 2500 Series Wireless Controller Getting Started Guide
About This Guide
5