Table of Contents
Advertisement
Figure 7
Use a 0.107-inch (2.7mm) or #32 drill bit to drill a 3/4 inch (19mm) hole for the two mounting screws.
Step 2
Insert two screws into the screw holes and tighten until the top of the screws are 1/8 inch from the wall
Step 3
(leaving enough room for the back panel to slide onto the screws firmly).
Place the controller onto the mounting screws and slide it down until it lock into place, as shown in
Step 4
Figure
8.
The front panel of the controller should be facing down.
Note
Mounting Screw Holes on the Back of the Controller
5.5
FRONT PANEL
Cisco 2500 Series Wireless Controller Getting Started Guide
Installing the Controller
15
Advertisement
Table of Contents
