Sony SU-PF2 Instructions Manual page 7

Assembling the Floating Stand
Tip
Lay the packing box of the Floating Stand, etc., on the floor and place the pillars on the box with their rear sides
(the side the cable cover is to be attached to) facing up. Set the box high enough that the bottom plate can stand
upright to stabilize assembly, as illustrated below. Also, if you spread the cushioning sheet on the floor,
damage to the floor can be avoided.
Attach the bottom plate to the pillars and secure them with screws.
1 Align the pillar screw holes with their respective hollows on the bottom plate.
2 Tighten all the screws to halfway, and then tighten each firmly.
Tip
Assembly can be made easier by temporarily securing the longer screws first.
Screw (small)
Screw (large)
Note
When using an electric screwdriver, set the torque setting to about 1.5N·m.
Do not use an impact driver. If you use an impact driver or an electric screwdriver with the torque
setting out of the specified range, screws may be excessively tightened, which may damage the screws or
product. The stand may fall and serious injury may result.
Bottom plate
Pillars with a glass panel
Use the packing box, etc.,
to align the screw holes.
7
(GB)