Table of Contents
Advertisement
R
epair
< 13 > Assembling swash bearing section
1. Apply grease to the parts of swash bearing section referring to < 1 > Lubrication at page 5.
2. Assemble swash bearing 10 by pressing cam shaft with arbor press as illustrated in Fig. 10.
3. Assemble helical gear 26 by pressing cam shaft with arbor press as illustrated in Fig. 10A.
4. Assemble flat washer 8, bearing retainer and ball bearing 608ZZ by pressing cam shaft with arbor press
as illustrated in Fig. 10B.
5. Assemble ring 8 by pressing cam shaft with arbor press as illustrated in Fig. 10C.
Cam shaft
Swash
bearing 10
Fig. 10
< 14 > Assembling swash bearing section to piston cylinder
1. Apply MAKITA grease to piston cylinder and swash bearing 10 referring to < 1 > Lubrication at page 5.
2. Assemble 2 pcs. of flat washers 12 and piston joint to piston cylinder as illustrated in Fig. 11.
3. Insert the above piston cylinder into inner housing as illustrated in Fig. 11A.
4. Bringing piston cylinder to the dead point for swash bearing 10, assemble swash bearing 10 to piston cylinder by
inserting its pole into the hole of piston joint as illustrated in Fig. 11B.
5. Fasten bearing retainer which has been assembled to swash bearing section, with adhesive hex socket head
bolt M4x12, onto inner housing as illustrated in Fig. 11C.
<Note> Do not fasten with the used hex socket head bolt M4x12. Always use the fresh adhesive
hex socket head bolt M4x12
Flat washer 12
Piston cylinder
Piston joint
Flat washer 12
Fig. 11
Flat washer 8
Bearing
Helical
retainer
gear 26
No.1R034
Bearing setting plate
Fig. 10A
Piston cylinder
Fig. 11B
Ball bearing
608ZZ
Fig. 10B
Fig. 10C
Inner housing
Fig. 11A
2 pcs. of Hex socket
head bolts M4x12 for tightening
bearing retainer.
P 14 / 19
Ring 8
Fig. 11C
Advertisement
Table of Contents
