Installing the Power Injector
Follow these steps to install the power injector:
Procedure
Step 1
The power injector is packaged with two Liquid Tight Cord Grips (LTCG) for RJ45 ports, and one AC power plug for
AC power cord assembly. Locate the 3-pin female cable end.
Step 2
Prepare line cord or AC Mains hardwire
Step 3
Slide the sealing nut (1) and cable gland (2) over the cable.
Step 4
If there is an outer jacket of cord, strip approximately 25mm (+/- 1mm) from the end.
5