Advertisement
Procedure
Step 1
Mark the hole locations using the following diagram as a template.
Step 2
Use 4mm (#8) max size screws, not supplied. Use hardware appropriate for mounting surface.
Step 3
Install lower 2 screws, leaving screw 3mm (1/8 in) from flush to allow unit to slide onto screws.
Step 4
Slide the unit onto lower screws.
Step 5
Install upper 2 screws through holes in handle.
Pole Mounting
Follow these steps to mount the power injector on a pole.
Procedure
Step 1
Use 12.7mm (1/2 in) max strap width.
Step 2
Install stainless steel straps through the slot in the chassis (2 places as shown, not supplied).
10
Advertisement
