Advertisement
Unpacking the Power Injector
The typical power injector package contains the following items:
• Power injector
• AC power plug
• Two Liquid Tight Cord Grips (LTCG) for RJ45 ports
If any item is missing or damaged, contact your Cisco representative or reseller.
Additional Requirements
Use the power cord to supply power for the injector. If you install the access point in an environmental air space such as above a
suspended ceiling, check national and local safety codes to make sure that the Ethernet cable you connect to the unit meets applicable
standards.
Note
Only qualified and trained service personnel (in accordance with IEC62368 and AS/NZS 3260) should install, replace, or
service the equipment. Install the system in accordance with Country, National or to the U.S. National Electric Code if you
are in the United States.
• The building facilities in which the product will be used must provide Isolation to the main AC Input connector. This connection
requires a fuse or circuit breaker no larger than 20A for 120 VAC (U.S.A.) or 16A, 230 VAC (international). The building
facilities must protect the power injector from over current or short-circuits.
• The power injector enclosure is IP67 tested which provides degrees of protection against access to hazardous parts, dust and
against ingress of water.
• The power injector enclosure must be mounted vertically handle up position for wall mounting option.
• The power injector enclosure has 2 threaded (M20x1.5) openings to accommodate Liquid Tight Cord Grip LTCG (provided)
and one watertight AC input socket.
• The power injector comes with an AC input plug for connecting with the AC power cord. The AC power cord 3 wire or cable
must be SJTOO type or better cord 3*18AWG, 5-15P plug and EP030-2224-01 coupler or in accordance with Country, National
Electric Code.
• The power injector consists of Data & Power ports. The ports provide TNV-1 outputs. The ports use RJ-45 data sockets. Do not
connect telephone cables into these ports. Only RJ-45 data cables with waterproof or watertight connections may be connected
to these sockets.
• To prevent the power injector from overheating, do not operate the product in an area that exceeds the maximum recommended
ambient temperature of -40 ºC to +65 ºC.
• Do not work on the power injector or connect or disconnect cables, during periods of lightning activity.
• The AC connector wire combination must be accessible at all times, as it serves as the main disconnect device to the product.
• Before servicing the product, always disconnect the product from its AC source.
• Equipment is for Pollution degree 2 Environment.
• Disposal of this product should abide by all appropriate National laws and regulations.
3
Advertisement
