Advertisement
Revised: July 28, 2023
Cisco Power Injector IW-PWRINJ-60RGDMG= Installation
Guide
This document describes the Cisco Power Injector IW-PWRINJ-60RGDMG= (referred to as the power injector in this document)
and provides instructions for mounting them.
Product Overview
The IW-PWRINJ-60RGDMG= power injector is powered by a single-phase AC voltage input in the range of 90VAC to 264VAC,
providing a maximum output of power at a nominal DC Voltage on the appropriate four data pairs of the output RJ45 connector. The
power injector meets the requirements of IEEE 802.3bt as a PSE. It can accept 10/100/1000/2500/5000/10000 Base-T traffic on the
input and output RJ45 connectors and pass through these signals between the network and the access point.
The following figure shows the ports and AC outlet arrangement.
1
Data and PoE Out RJ45
2
Data only RJ45
2
3
Ground lug
4
AC input
Advertisement
