Makita DHP458 Instruction Manual page 8

Adjusting the fastening torque
(screwdriver mode)
1
► 1. Adjusting ring 2. Graduation 3. Arrow
The fastening torque can be adjusted in 21 steps by
turning the adjusting ring so that its graduations are
aligned with the pointer on the tool body.
First, slide the action mode change lever to the position
of symbol.
The fastening torque is minimum when the number
1 is aligned with the pointer, and maximum when the
marking is aligned with the pointer. The clutch will
slip at various torque levels when set at the number
1 to 21. Before actual operation, drive a trial screw
into your material or a piece of duplicate material to
determine which torque level is required for a particular
application.
NOTE:
• The adjusting ring does not lock when the
pointer is positioned only halfway between the
graduations.
Empty signal for remaining battery
capacity
(Country specific)
Only for tools with the button and
LED indicator
► 1. Button 2. LED indicator
Stop the tool and with the tool stopped press the button
on the switch panel and the remaining battery capacity
will be signaled on the panel.
The status displayed on the switch panel and the
remaining battery capacity is shown in the following
table.
LED indicator status
2
3
NOTE:
•
ASSEMBLY
CAUTION:
•
Installing side grip (auxiliary handle)
► 1. Groove 2. Protrusion 3. Steel band 4. Grip base
5. Side grip
Always use the side grip to ensure operating safety.
Insert the side grip so that the protrusions on the grip
2
base and steel band fit in between the grooves on the
tool barrel. Then tighten the grip by turning clockwise.
1
When you turn the side grip, loosen and remove the
grip, then turn the grip and insert it again.
8 ENGLISH
Remaining battery capacity
About 50% or more
About 20% - 50%
About less than 20%
Before checking the remaining battery capacity,
be sure to stop the tool.
Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
2
1
3
4
5