Operation - Makita BAC01 Instruction Manual

ASSEMBLY
CAUTION:
Hold the power converter and the
power source firmly when installing or removing
power source. Failure to do may cause them to slip
off your hands and result in personal injury or damage
to the power converter and the power source.
CAUTION:
Before operation, make sure that
the cord is placed properly and the socket is
inserted into the plug all the way.
Mounting the power source
For PDC1200
Attach the power source to the power converter as
shown in the figure.
CAUTION:
Make sure that the power source
is securely installed to the power converter.
Otherwise it may accidentally fall out of the power
converter and cause injury to you or someone around
you. If you can see the red indicator as shown in the
figure, the power source is not locked completely.
► Fig.2: 1. Red indicator
When removing the power source, lift the power source
up while pushing down the lock button.
► Fig.3: 1. Lock button
For PDC01
Attach the power source to the power converter as
shown in the figure.
► Fig.4
To remove the power source, perform the installation
procedure in reverse.
Connecting the power source
1. Open the cap of the plug.
2. Align the arrow mark on the socket with that of the
power converter, and then insert the socket into the plug
all the way.
► Fig.5: 1. Cap 2. Plug (input) 3. Socket 4. Arrow
mark
NOTICE:
Do not insert the socket forcibly. If
the socket cannot be inserted easily, it is not being
inserted correctly.
NOTICE:
When unplugging, do not hold the
cords but hold the socket. Otherwise, the cords
may be damaged and cause a malfunction.
NOTICE:
Always close the cap of the plug firmly
when the power source is not plugged. Otherwise
foreign matter may enter the power converter and
cause a malfunction.
Cord pocket
You can put the cord into the cord pocket as shown in
the figure.
► Fig.6
Installing MAKPAC
Optional accessory
The power converter can be attached to the top or
bottom of MAKPAC as shown in the figure.
► Fig.7
CAUTION:
Make sure that the power con-
verter is securely fixed to the MAKPAC with the
four latches. Otherwise falling accident may occur
and cause personal injury.

OPERATION

► Fig.8: 1. Power button
1.
Press the power button of the power source to turn
it on.
2. Connect your appliance to appropriate output.
When using AC output, select appropriate frequency by
pressing and holding the frequency switching button.
NOTE: The frequency can be selectable only when
the AC output stops.
NOTE: Frequency setting is memorized. Next time,
the power converter will start with the same setting.
3. Press the output button you want to use.
The power converter starts the output and the output
button at work lights up.
4.
Press the output button again to stop.
5. Press the power button of the power source to turn
it off.
NOTICE:
You may not be able to use an appli-
ance which requires a large amount of power to
start up even if the power output of the power
converter is kept within the rated power range.
NOTICE:
The power converter may not supply
power to some USB devices.
NOTICE:
Before connecting USB device to the
power converter, always backup your data of USB
device.
NOTICE:
You cannot charge the power source
with the power converter using power banks
available in the market.
9 ENGLISH