Cisco 7541 Hardware Installation Manual page 49

Chapter 5 WAVE Interface Modules
Table 5-3
2
3
Figure 5-9
interface designations, and LEDs.
Figure 5-9
2 Port 10GE SFP+
Note
The 2-Port Fiber Optic 10 Gigabit Ethernet SFP+ Interface Module does not support mechanical bypass.
The Interface Module has an LED that corresponds to each port.
Table 5-4
LED Name
1
2
Fiber Optic Interface Module—Power and Status LEDs
Activity Green
Blinking
—
Bypass status Green
Amber
shows the 2-port Fiber Optic 10 Gibabit Ethernet SFP+ Interface Module port numbers,
2-Port Fiber Optic 10 Gigabit Ethernet SFP+ Interface Module—Port Numbering and LEDs
2 3
A S
10GE 0
1 4
Inline Network Adapter LEDs
Color
Interface Module Green
Power LED
—
Activity —
Green
Green
Yellow
Cisco Wide Area Virtualization Engine 7541, 7571, and 8541 Hardware Installation Guide
On Link exists.
Off Transmitting.
Off No link detected.
Normal Indicates the inline port pair is in interception
mode.
Bypass Indicates the inline port pair is in bypass
mode.
A S
10GE 1
State Description
On Interface Module is receiving power.
Off Interface Module is not installed or a power
supply failure has occurred.
Off No link is detected.
On Link is detected.
Blinking Transmitting.
On Interface Module is administratively shut
down.
Ports and LED Indicators
Table 5-4 describes the LEDs.
5-7