Black & Decker BD17204 Instruction Manual page 6

WARNING
overfilling prevention device and a QCCI
or Type I, (CGA791) propane gas tank
connection.
• This heating appliance should not be used on
plastic or artificial wood decks.
• Children and adults should be alerted to the
hazards of high surface temperatures and
should stay away to avoid burns or clothing
ignition.
• Young children should be carefully
supervised when they are in the vicinity of
the heater.
• Clothing or other flammable materials
should not be hung from the heater, or
placed on or near the heater.
• Any guard or other protective device
removed for servicing the appliance shall
be replaced prior to operating the heater.
• Installation and repair should be done
by a qualified service person. The heater
should be inspected before use and at least
annually by a qualified service person.
More frequent cleaning may be required as
necessary. It is imperative that the control
compartment, burners and circulating air
passageways of the heater be kept clean.
• Storage of an appliance indoors is
permissible only if the cylinder is
disconnected and removed from the
appliance. A cylinder must be stored
outdoors in a well-ventilated area out of the
reach of children. A disconnected cylinder
must have dust caps tightly installed and
must not be stored in a building, garage or
any other enclosed area.
• Place the dust cap on the cylinder valve
outlet whenever the cylinder is not in use.
Only install the type of dust cap on the
cylinder valve that is provided with the
cylinder valve. Other types of caps or plugs
may result in leakage of propane.
• Installation of this appliance at altitudes
above 2000 ft (610 m) shall be in accordance
with local codes, or in the absence of local
codes, ANSI Z223.1/NFPA 54 or CSA B149.1.
• Appliance may shut down in windy
conditions in excess of 3 miles per hour (4.83
kilometers per hour).
• Check the hose assembly for signs of
extreme abrasion, cuts or wear. Suspected
areas should be leak tested. If the hose leaks,
inspect the visible portion of the hose before
each use of the appliance and inspect the
entire hose assembly at least annually. If
disassembly is required, properly check the
connections for leaks upon re-assembly. The
hose assembly must be replaced prior to the
appliance being put into operation if there
is evidence of excessive abrasion or wear,
or if the hose is damaged. The replacement
hose assembly shall be that specified by the
manufacturer.
• This appliance shall be used only in a well-
ventilated space and shall no be used in a
building, garage, or any other enclosed area.
WARNING
An appliance may be installed with shelter no
more inclusive than the following:
1 . With walls on all sides, but with no overhead
cover.
2 . Within a partial enclosure, which includes
an overhead cover and no more than two
side walls. These side walls may be parallel,
as in a breezeway, or at right angles to each
other.
3 . Within a partial enclosure which includes an
overhead cover and three side walls, as long
as 30% or more of the horizontal periphery
of enclosure is permanently open.
No obstructing the flow of combustion and
ventilation air.
Only use the regulator and hose assembly
provided with this unit. Replacement parts must
be supplied.
Inspect the burner before use of this unit. If
the burner shows any kind of damage, do not
operate the appliance. For assistance with
repair or replacement of the burner or any
other parts, call the manufacturer
at 1-877-447-4768.
NOTE: You must follow all steps to properly
assemble this heating item. Make sure the gas
valve is turned 'OFF' before assembling. Do
NOT attempt to assemble without proper tools
BE CAREFUL: WHEN CERTAIN MATERIALS OR
ITEMS ARE STORED ABOVE, BESIDE
OR UNDER THIS HEATER WHILE IN USE,
THEY WILL BE SUBJECT TO RADIANT HEAT
AND COULD BE SERIOUSLY DAMAGED.
WARNING
Combustible materials should not be within
48 inches of the top of the unit, or within
48 inches around the entire unit.
48"
48" 48"
6