Black & Decker BD17204 Instruction Manual page 10

4. Remove the 4 preassembled M6x12 bolts
(DD) from the burner assembly (H). Attach
3 M8 studs (GG) and 3 washers (FF) to the
burner assembly (H). Tighten the M8 studs
(GG).
GG
FF
H
DD
WARNING:
Remove protective film on reflector
panels (M) and (N) before assembling
5. Attach the 4 reflector panels (M) to the
center reflector (N) using 12 M6x10 screws
(II) and 12 cap nuts (JJ). Fully tighten all
the screws.
JJ
M
6. Slide 3 washers (FF) over the threaded end
of studs. Attach the top reflector assembly
made in step 5 to the top of the M8 studs (GG)
using 3 washers (FF) and 3 wing nuts (HH).
7. With the help of another person, insert the
regulator (I) from the top end of the support
pole (G), then attach the burner head made in
the last step to the support pole (G) using the 4
M6x12 bolts (DD) removed at the beginning of
step 4. Be sure that the control knob faces the
door side. Tighten bolts securely.
N
8. Use the anchors (LL) to fasten the product
into the ground.
II
LL
FF
HH
FF
GG
I
DD
G
10