Controls - Detailed Description - Smeg GW0160 Series User Manual

4.2

CONTROLS - DETAILED DESCRIPTION

BUTTONS
User manual
DESCRIPTION
On/Off
The button is operational with the door opened or closed.
The button turns the device's interface on and off, allowing its use. Hold it down for 2
seconds for both switch-on and switch-off.
Once the appliance has been switched on, the code of the selected program appears on
the display (e.g. "Pr 03").
When the interface is switched off, the display shows a flashing "OFF" message.
When the door is open, the display shows 4 horizontal dashes and none of the other
interface buttons are active.
The device is still powered up even when the interface is off.
Start/Stop
This button starts the selected cycle or interrupts a cycle in progress. It must be held
down for 2 seconds.
Two beeps sound when a cycle is started or stopped.
The button is also used (again holding it down) to confirm the value of an appliance
parameter during modification.
Functions
Hold down: access to the appliance setup parameters, password required. Refer to the
SETUP MODE - "FUNCTIONS" section for a detailed explanation.
Short press: whenever the Functions button is pressed,
the display screen changes; the various screens show the parameters of the cycle
selected in combination with the LED which explains their meaning.
For a full understanding of the values shown on the display, note that they depend on the
appliance's status:
1. Appliance in standby
2. Washing cycle running
LED ON DISPLAY
1 : 16
-- : 90
600
- F5
GW0160 Series
Meaning of LED on
With appliance in standby
The value is the nominal duration of the cycle. The time LED
also illuminates. The duration is guideline; it applies in test
conditions and with correct electrical connection.
With cycle running
Time left to end of current cycle
With appliance in standby
Maximum temperature reached in the cycle set
With cycle running
Temperature in chamber
With appliance in standby
A value associated to the selected cycle, if the cycle includes a
0
thermal disinfection phase.
With cycle running
Display function which starts from the thermal disinfection
phase: displays the A value reached.
0
The value reached during the thermal disinfection phase is
displayed during the phases which follow.
[The parameter is displayed on two consecutive display
screens. The value in thousands is indicated by the suffix "t", in
units with the suffix "u"]
With appliance in standby
Number of phases in the program
With cycle running
Current phase
N.B.: Washing cycles always start with a short draining phase to
bring the device to the standard starting condition: this phase is
Page 15 - 70