Deactivation Character; Illumination Lights; Aimer Delay - Honeywell Voyager XP 147 Series User Manual

Deactivation Character

This sets the character used to terminate scanning when using Character Deacti-
vation Mode. On the
that represents the character you want to use to terminate scanning. Scan the fol-
lowing barcode, then use the
nation that represents that ASCII character. Scan Save to finish.

Illumination Lights

If you want the illumination lights on while reading a barcode, scan the Lights On
barcode, below. However, if you want to turn just the lights off, scan the Lights Off
barcode. Default = Lights On.
Note: This setting does not affect the aimer light. The aiming light can be set using
Mode
.

Aimer Delay

The aimer delay allows a delay time for the operator to aim the scanner before the
picture is taken. Use these codes to set the time between when the trigger is pulled
and when the picture is taken. During the delay time, the aiming light will appear,
but the LEDs won't turn on until the delay time is over. Default = Off.
Voyager XP User Guide
ASCII Conversion Chart (Code Page
* Lights On
200 milliseconds
Programming Chart
Deactivation Character
1252), find the hex value
to read the alphanumeric combi-
Lights Off
400 milliseconds
Aimer
87