Diagnostic Program; General - Casio IT-2000 Service Manual

7. DIAGNOSTIC PROGRAM

7.1 General

Diagnostic program is made for diagnosing the IT-2000 hardware.
This section shows operating instruction of the diagnostic program with using the Flash ROM card.
7.1.1 Install the diagnostic program to Flash ROM card
1 Prepare for Casio Flash ROM card and the diagnostic disk.
2 Copy all files in the diagnostic disk to Flash ROM card.
Diagnostic disk files are listed in 7.1.4.
Note: Casio Flash ROM card is recommended. If used the other card it may not work normally.
7.1.2 Boot operation
1 Set the Flash ROM card to IT-2000.
2 Press the INIT button.
3 Power turn off after the system menu is displayed.
4 Power turn on again.
5 Select "1. use HIMEM".
6 Press "1" "1" "9" "
Test menu appears on the display.
Note: Select "2. Not use HIMEM" in operating IrDA test. IrDA test is not able to execute when
HIMEM is in effect.
7.1.3 Execute the each test
1 Select the test number from the menu on the display and press "
2 Each test is executed.
When the test is complete it returns to the menu. Otherwise error message will be displayed.
3 To get out of the error display press "CLR".
Note: Use the matrix key when selecting a number. Touch panel does not work.
".
— 30 —
".