Hitachi WJ200 Series Quick Reference Manual page 52

Monitoring functions
NOTE: Marking [  ],[  ],[
 : Configuration changes are possible during operation.
: You cannot change the parameters during operation.
*
1: In case of (b031) soft lock selections"10", parameter changing during operation is
possible.
Please change from"
b037
(Function code display restriction), in case some parameters cannot be displayed.
IMPORTANT
Please be sure to set the motor nameplate data into the appropriate parameters
to ensure proper operation and protection of the motor:
 b012 is the motor overload protection value
 A082 is the motor voltage selection
 H003 is the motor kW capacity
 H004 is the number of motor poles
Please refer to the appropriate pages in this guide and the Instruction Manual for further details.
Func.
Code
d001 Output frequency monitor
Output current monitor
d002
Rotation direction monitor
d003
Process variable (PV),
d004
PID feedback monitor
*
1 ],in the table show following meaning.
04
(Basic display)" to "
" d " F u n c t i o n
N a m e
00
(Full display)" in parameter
D e s c r i p t i o n
Real time display of output frequency
to motor from
0.00 to 400.0Hz
If b163 is set high, output frequency
(F001) can be changed by up/down
key with d001 monitoring.
Filtered display of output current to
motor, range is
0.0 to 655.3 ampere (~99.9 ampere
for 1.5kW and less)
Three different indications:
"F" Forward
"" Stop
"" Reverse
Displays the scaled PID process
variable (feedback) value (A075 is
scale factor),
Range is
0.00 to 99.99 (0.00 to 99.99) /
100.0 to 999.9 (100.0 to 999.9) /
1000. to 9999. (1000 to 9999) /
1000 to 9999 (10000 to 99990) /
100 to 999 (100,000 to 999,000)
46
Run
Mode Units
Edit

Hz

A
 
% times

constant