Table of Contents
Advertisement
3.
Installation
3.1 Conditions for Installation
Laser beam printer is likely influenced by the environment of set-up location.
IF Printer was set up at the inappropriate location, the printer may not perform
the characteristic functions as expected.
should be taken into consideration prior to deciding where to set.
(1). Environmental Conditions
Printer should not be set up at the locations referred to by the following
items (a) through (d) specifying the inappropriate locations for set-up.
(a). Likely to receive the direct sunbeam or similar light.
(For example, window side)
(b). Likely to cause the big difference in temperature and humidity between
the maximum and minimum level.
within 10
(c). Likely to receive cold wind from air-conditioner or worm wind from
heater, or to receive direct radiant heat.
(d). Likely to cause much dust or have corrosive gas like ammonia.
(e). Users to select the location of good ventilation and set a printer on the
flat surface.
(f). Users to check the maximum tilt of set-up location to be within 1 .
(2). Basic Layout of Printer Set-Up Location
Fig.3-1 shows the basic layout of printer set-up location suitable for the
smooth operation and maintenance of printer.
C
~ 35
C
, 20 ~ 80%RH and without any condensation.)
40cm(16")
3-1
Therefore, the following factors
(Normal operation environment is
10cm(4")
10cm(4")
[Fig.3-1]
70cm(28")
Advertisement
Chapters
Table of Contents
