How To Use - Makita MW001G Instruction Manual

buzzer beeps once, and displaying code: F09.
Tilt protection
The appliance cannot operate when the appliance is
tilted. If the appliance is tilted, the error code: F01 is
displayed. Place the appliance horizontally and restart
operation.
Protections against other causes
Protection system is also designed for other causes that
could damage the appliance and allows the appliance to
stop automatically. Take all the following steps to clear
the causes, when the appliance has been brought to a
temporary halt or stop in operation.
When the error code is displayed, refer the section for
the error code.
1. Turn the appliance off, and then turn it on again to
restart.
2. Charge the battery(ies) or replace it/them with
recharged battery(ies).
3. Let the appliance and battery(ies) cool down.
If no improvement can be found by restoring protection
system, then contact your local Makita Service Center.

HOW TO USE

Installing or removing battery
cartridge
CAUTION:
Always switch off the appliance
before installing or removing of the battery
cartridge.
CAUTION:
Hold the appliance and the bat-
tery cartridge firmly when installing or removing
battery cartridge. Failure to hold the appliance and
the battery cartridge firmly may cause them to slip off
your hands and result in damage to the appliance and
battery cartridge and a personal injury.
To remove the battery cartridge, slide it from the
appliance while sliding the button on the front of the
cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
2
1
Fig.6
► 1 . Red indicator 2. Button 3. Battery cartridge
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
NOTE: Up to two battery cartridges can be installed,
although the appliance uses one battery cartridge for
operation.
If you install two batteries, the appliance use the
battery on the right side of the figure first.
BASIC OPERATION
Turning on/off the appliance
Press the power switch for about 0.5 seconds to start
the appliance with one beep. After starting the appli-
ance, the control panel displays microwave power of
500W, working time of 0 and battery power information
by default and all button lights are on.
If there is no other operation within 3 minutes, it will be
shut down automatically, and the display screen and
button lights will all go out to enter the power off state.
After power on, press the power switch for about 0.5
seconds to shut down in any state, including heating.
Microwave function
There are two fire power levels, 500W and 350W,
respectively.
Press the power selection button to switch between
500W and 350W, the control panel displays the corre-
sponding level.
After the power is selected, turn the time adjustment
knob clockwise to increase the time and counterclock-
wise to reduce the time. The maximum setting time is
20 minutes.
After selecting the power level and time, short press the
start button to start microwave heating. A buzzing sound
to notify completion of the operation.
After the microwave starts to output, short press the
pause/stop button to pause the microwave output.
To resume the operation during pause, short press the
start button.
8 ENGLISH
3
1